About h4831sc

H1000 is on my desire listing of powders also. Perhaps the IMR Enduron series are going to be perfectly liked and I am able to shift to that for superior availability.

H4831SC Powder obtainable in inventory now. Ballistically, this Severe Extruded powder is the precise duplicate of H4831. Physically, it's got a shorter grain dimension, hence, the designation SC or limited cut. The shorter, much more compact kernels enable the powder to flow from the powder measures far more smoothly, assisting to relieve the regular reducing of granules.

Can they be interchanged with no concerns other then employing usual load tactics when switching from lot to great deal?

Minnesota H4831SC is my visit within the 7mm Rem Mag, but I'm conserving the minimal I've left for fall 2021. I'd start off lower and do the job your way up, depending on what load data you examine for this combo the min/max loads are all around the board.

My experience would be that the SC and SSC loaded to the exact same bodyweight given that the extended Slash exhibits a decreased velocity.

I've made use of H4831 and H4831SC in my 260 Rem with no variation. The one thing could be the small Slice provides a little bit more House. Great luck!gun)

I have utilized both equally and employed the very same costs and also have not been in a position to notify any noticable variations with general performance. the SC Edition meters slightly smoother is about all. any feedback??

If you have some heavier .224" bullets, you would possibly find a load that works Okay While using the 4831. The bullets I tried that were above 70 grains would not stabilize in my rifle, which experienced the standard 14" twist. The 70-grain Speer was the greatest bullet that could stabilize, but it really did that fantastically. It h4831 vs h4831sc is a amusing-on the lookout bullet having a rounded nose profile, nevertheless it shoots good and kills perfectly. Deer out to about a hundred and fifty yards al went down right away h4831sc load data with rib-cage hits.

The main reason I switched from IMR 4831 to H4831 was to benefit from the temperature insensitivity of a Hodgdon Extraordinary powder.

You may have to generate some much more posts to have cleared to do PM's. After you get to that status I'd put up in the categorised reloading portion to discover if everyone is near you for your trade. Simply click to extend...

So glad your getting much more types of powder back in. Now you'll want to get primers back again in stock and reloaded can commence reloading once again.. just expressing

Of course, You need to use the identical load data for H4831 vs H4831SC, but the SC Model could allow you to get a tiny bit additional in predicaments where you are maxing out situation quantity Together with the regular powder right before reaching force limits.

Nevertheless IMR 4831 and H4831SC are various powders, you'll discover that in several instances, exactly where one of them is shown the opposite are going to be as well. Also, you'll find there is a fairly steady romance concerning them with regard to listed loads.

If I've a pound or two of the powder and obtain additional of exactly the h4831 vs h4831sc same, only a unique great deal selection, I will mix all of them up to ensure that I have a homogeneous batch of powder with which to operate.